Part Number:LM5161
Tool/software: WEBENCH® Design Tools
Dear Sir/Madam,
I am trying to design a Buck converter with an input voltage between 4.5V and 85V ( the requirement is from 5-82 but for safety margin I want it to be a little wider).
The lowest voltage that I can use is 5.3V to 85V.
If I look at the specs of LM5161 then it is possible to design a Buck converter with an input voltage range from 4.5V to 100V.
Why is this not possible in the WEBBENCH Design Tools?
It would be very useful for me if it works because I can do simulations with the tool.
Can someone help me or tell me what I missed or do wrong?
I would like to thank you in advance and I am looking forward to your reply.
Regards,
Roberto del Pozo Gallardo