Dear TI,
I have upload this below questions but nobody answer it.
So I upload it again.
I am trying to make single phase inverter using TIDA-01606.
I have several question and need suggestions about it.
1. What is the purpose of the inverter current measurement?
- Based on my knowlege, it has a lot of noise because it is located before the fitler. I think it is useless.
2. Suggestion for the modificiation.
- I am trying to modify three phase inverter to sinlge phase inverter.
But when I am trying to to it in the Altium, it is not working well.
- I think the reason is that I don't have the library.... Do you have any suggestion?
3. Any update from the reference documents.
- I believe it should have some update.
Could you let me know the update from the reference documents?
- And could you provide any suggestions when I build the HW?
Best regards,