LM5170-Q1: How do I design a circuit to drive a four-phase buck mode?

Tool/software:

Hello Sir,

I have already confirmed the 2-Phase Buck mode operation using the LM5170 device through the TINA Simulation data of the existing TI Forum.

Since then, a 4-Phase configuration has been required to obtain a higher output value, but it has not proceeded because it is difficult to write about the design of the simulation circuit.

Also, I checked the manual of LM5170-Q1 EVM, but I was unable to design the simulation circuit.

So I'm wondering how to design the TINA circuit. Of course, I know that I have to use two LM5170 devices.

Please Let me know that...

Thank you,

Best Regards,