TIDA-00792: Need of EV2400 for TIDA-00792 , required or not? Can TIDA-00792...
Part Number:TIDA-00792Dear all,Wanted to confirm , that will TIDA-00792 will work without EV2400?Or it will require permanently, as seen in documents TIDA-00792 consists of chip 78350 & BQ76940 as...
View ArticleTIDA-060001: Is that ok to replace TMS320F28379D with a low end C2000 in...
Part Number:TIDA-060001Hi Team,Is that ok to replace TMS320F28379D with a low end C2000 in TIDA-060001? TMS320F28379D is too expensive. If yes, what is the requirement for the MCU? Which C2000 do you...
View ArticleTINA/Spice/TINA-TI: Changes
Part Number:TINA-TITool/software:TINA-TI or Spice ModelsHi,What has been changed between the TINA-TI V9.3.150.328 and V9.3.200.277?Unfortunately the "readme.txt" file has not been updated.Thanks and...
View ArticleWEBENCH® Tools/LM5176: Webench export to TINA-TI fails
Part Number:LM5176Tool/software: WEBENCH® Design ToolsI'm trying to export a customized LM5176 design from webench power designer to TINA-TI for simulation, but the export fails. The new HTML5 based...
View ArticleTINA/Spice: supply voltage greater than specified
Tool/software:TINA-TI or Spice ModelsScratching my head on this one. Sorry if this has been discussed before.I set up a sim with voltage supply, and inductor and a resistor all in series. If I set...
View ArticleWEBENCH® Tools/TPS82140: "Design update failed. Junction temperature is too...
Part Number:TPS82140Tool/software: WEBENCH® Design ToolsWebench faithfully simulates a 9-13V input / 3.3V 1@A output using the TPS82140If the output current spec changes to 3.3V @0.5A, I receive the...
View ArticleWEBENCH® Tools/LM5145: LM5145 device fails due to non-availability of...
Part Number:LM5145Tool/software: WEBENCH® Design ToolsI made a LM5145 and LM5146Q design with Webench: 42V to 52V input, 28V/7.2 output .LM5145 device fails due to non-availability of Mosfets.LM5146Q...
View ArticleTIDA-010030: Msp Controller source code for Tida-010030 eval board,including...
Part Number:TIDA-010030Hi,I wanted to start to work with TIDA_010030, prior to it, am wondering if TI provides source code for MSP controller or not?As per the hardware designed (TIDA-010030) , source...
View ArticleWEBENCH® Tools: Can WEBENCH provide log file or other file that can express...
Tool/software: WEBENCH® Design ToolsI would like to know if WEBENCH could provide log file or other file that can express the procedure in power management design?I would like to do educational...
View ArticleClik here to view.
PMP10833: smps layout review
Part Number:PMP10833Dear expertI have designed smps of 15V/1A with reference design of PMP10833I have attached schematic and pcb layout(Placement of components) for review purpose.Pls review below...
View ArticleTIDA-01398: IRS-B210ST01-R1 Scheduled for obsolescence
Part Number:TIDA-01398Hi I am Prakash, working for Connectm Technologies, I am interested in TIDA-01398 device, I was going through the BOM and found IRS-B210ST01-R1 is scheduled for obsolescence, So...
View ArticleClik here to view.
TIDA-01580: Questions about checking operation
Part Number:TIDA-01580HelloI made a new board with reference to TIDA-01580 circuit diagram(RLD mode).I put the following waveform on the board and check the output waveform.--> 2mV , Sine Wave1....
View ArticleTIDA-01477: it is possible to add load cell to this board
Part Number:TIDA-01477Dear Experts,i have doubt in this board design, i have a idea to collect weight, humidity and temperature from multiple nodes, and one TIDA-01477 board is connect through UART...
View ArticleTIDA-01505: Start up circuit
Part Number:TIDA-01505Hello,Had query on Active Startup circuit: 1. STP03D200 BJT has minimum hfe value of 230 and 200 for Ic=20mA and 30mA, why is the assumed hfe value is 500?2. Rstart_slow value...
View ArticleTIDA-050018: TIDA-050018
Part Number:TIDA-050018HelloPlease check in document http://www.ti.com/lit/ug/tiduek0/tiduek0.pdfin chapter 3.4 Battery Life Estimation:Considering 5-years lifetime, the total capacity is used by the...
View ArticleClik here to view.
PMP20058: Reducing Output Ripple of Flyback Boost Regulator
Part Number:PMP20058The PMP20058 Reference Design is an isolated flyback regulator intended to provide 54V for Power-over-Ethernet (PoE) applications.IEEE 802.3af (PoE) indicates that the maximum...
View ArticleTIDA-00548: Source Code for Reference Design
Part Number:TIDA-00548Hello team,Is there any source code available for TIDA-00548? My customer is fabricating the boards for evaluation and will need the software to test specifications.Thanks!Errol
View ArticleWEBENCH® Tools: Level Translator solution
Tool/software: WEBENCH® Design ToolsHi,We are looking to design a level shifter for an I2C bus between our system and a target device. Thespecifications for each are as follows:System: 3.3V I2C bus (2...
View ArticleSimulation, hardware & system design tools forum
Part Number:WEBENCH-POWER-DESIGNERTool/software: WEBENCH® Design ToolsHiNew Webench tools would be based on HTML.Could we use new Webench on any browser?If not, is there recommended browser and...
View ArticleTIDA-01573: How can guarantee the fast turnoff speed of the Laser Diode
Part Number:TIDA-01573Hello,I want to know when place a Schottky diode paralling with the laser diode,how can guarantee the fast turnoff speed of the Laser Diode.Because when the GaN turn off, the...
View Article